Garage door spring replacement in Queens
The spring, not the opener, carries the weight of your door. When one breaks the door becomes far too heavy for the motor and for you, usually announcing itself with a bang loud enough to bring you outside.
This is the single most commonly mispriced job in the trade, which is exactly why the published range is on this page.
Springs are rated in cycles, not years
One open and one close is a cycle. A standard torsion spring is rated at roughly 10,000 cycles and a high-cycle spring at about 20,000, which Angi and Bob Vila both translate to somewhere between seven and fifteen years of ordinary use.
So a spring that broke has usually finished, not failed. A household that uses the garage as its main entrance gets through cycles far faster than one that does not.
Both springs, and ask the cycle rating
If one spring has reached the end of its cycle life, the other is close behind. Replacing only the broken one means paying the call-out twice and leaves the door unbalanced in the meantime.
A high-cycle spring costs modestly more and can roughly double the service life. For a busy household it is the better buy, and it is worth asking for by name.
Do not attempt this one yourself
Every source we researched says the same thing, unusually bluntly. A wound torsion spring stores a very large amount of energy and releases it violently if a winding bar slips.
It is the one job on this site where we would rather you closed the page than tried it.
Common questions
- Can I still get my car out?
- Most openers have an emergency release cord that lets the door be moved by hand. With a broken spring it will be extremely heavy and will want to drop — that genuinely needs two able people, and often it is better to wait.
- Why do published prices vary so much?
- Because sources survey different contractors in different years. Angi's New York figure is $169–$394 for a single torsion spring; Bob Vila's national figure for both springs on a double door is $150–$300. Both are on our cost guide, disagreement included.
| Torsion spring replacement, single springAngi (New York), 2026Labor alone runs $85–$170 residential. Springs are replaced in pairs when one fails, to keep the door balanced — expect roughly double for both. | $169–$394avg $282 |
|---|---|
| Torsion spring replacement, single springAngi, 2026 — national figureUp to $500 where a multi-door or related repair is involved. | $150–$350 |
| Torsion springs, both, double doorBob Vila, 17 April 2024 — national figureNotably lower than Angi's single-spring New York figure. Bob Vila's national numbers run below Angi's throughout; both are published here rather than averaged. | $150–$300 |
| Extension spring replacement, per springBob Vila, 17 April 2024 — national figureCheaper than torsion, and shorter-lived. No New York specific figure was published by any source we could verify. | $100–$200 |
Your quote can come in below these ranges, and it can come in above them. Both happen for legitimate reasons: a simple reset costs less than a full replacement, and difficult access, a heavy or non-standard door, seized hardware, or damage found once the door is open all cost more. These are published by the sources named, not by us, and nobody can price your door from a web page. Use them to start a conversation, not to end one.
- Are you replacing both springs?
- What cycle rating are these — 10,000 or 20,000?
- Is the price in writing before you begin?
- Will you rebalance the door and test the opener's force settings after?
Also worth reading
- The full guide to this faultWhat causes it, what to check yourself, and what it costs→
- Garage Door RepairA door that sticks, grinds, reverses, or stops halfway. The broadest category and the most common call.→
- Opener Repair & InstallationMotor runs but nothing moves, remote stops working, or the unit is old enough to replace.→
- New Door InstallationReplacing a door outright — steel, carriage, aluminium or wood, measured and hung.→
Tell us what the door is doing.
Five questions, about ninety seconds, no payment details. Castle Garage Door Network does not do the work — independent contractors do, and they contact you directly.